Paul C. Buff, Inc. Technical Forum

ok...i know i'm missing something here but i can't quite figure this out. got my mess-o-PCB stuff this week and i'm trying to configure the CC to work with the Einstein units. under "SPEC LIGHTS" menu i have an option for AB/WL/Zeus/Other. where do the Einstein units fit in?

please give me the obvious answer i'm clearly overlooking

thanks in advance

k

1. Power up your Einstein(s), and use the back panel to assign the frequency and channel number(s).
2. Turn on the CC, and make sure it's configured for the same frequency that you set on the Einstein(s).
3. Use "Open All from Studio" on the CC, and all Einsteins that are powered up will be detected automatically.

FYI - I asked the same question last week, so you're not alone.

whew! thank you *so* much! (glad i'm not alone)