Paul C. Buff, Inc. Technical Forum

Technical Discussion Forum for all Paul C. Buff, Inc. Products

Login

Post a reply
 [ 3 posts ] 

Wed Jun 17, 2015 8:57 pm

Joined: Wed Jun 03, 2015 6:15 pm
Posts: 5

I just picked up 2 CSRB+ units secondhand, to go along with my CyberCommander to trigger & control my Alien Bees until I upgrade to Einsteins. One of the CSRB+ units works just fine, while the other does not. I'm following the directions precisely: Turn on B800, set to full power, insert dummy plug, push all rear buttons in, then connect phone jack/CSRB+. For the unit I can't get to work, the red dump light stays on (on the B800) and never goes green. I can get one test flash off, then it won't fire anymore. Am I missing something?




Top Top
Profile
 

#

Thu Jun 18, 2015 7:58 pm

Joined: Wed Jun 03, 2015 6:15 pm
Posts: 5

Disregard- today it seems to be working just fine. Didn't change anything, not sure what the issue was.




Top Top
Profile
 

#

Fri Jun 19, 2015 10:20 am

Site Admin
Joined: Tue Dec 08, 2009 10:43 am
Posts: 5266

Remember to push UP on the right joystick while in the main screen of Commander. This will engage the Refresh function. By doing this will help "wake up" receivers.




Top Top
Profile
 
Display posts from previous:  Sort by  
Post a reply
 [ 3 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 68 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum