First, Be sure you are distinguishing between the test fire only function of the Cyber Commander (left joystick) and the fire+meter function (the right joystick). Only the right joystick will update the meter reading.
Next, go to SETUP, then FLASHMETER. Enter the FLASHMETER window, and you should see the letters "CAL" in the upper right. Make sure that is set to "0.0F". Also, in the upper left corner, be sure your shutter speed and ISO are set to match your camera.
Lastly, and you may have done this, go to SETUP>ADVANCED CONFIGURATION>FACTORY CALIBRATION then use the left/right function of the left joystick to reset it to factory calibration.
|