Paul C. Buff, Inc. Technical Forum
http://paulcbuff-techforum.com/

Cyber Commander - won't start after changing batteries
http://paulcbuff-techforum.com/viewtopic.php?f=8&t=50		 Page 1 of 1
Author:  AlanG [ Fri Dec 18, 2009 11:31 am ]
Post subject:  Cyber Commander - won't start after changing batteries
When I change the batteries in the Cyber Commander, it won't come back on unless I remove the memory card and re-insert it. Sometimes I have to do this several times before the unit will activate. Is there something wrong or will this be corrected in the firmware?

I also have the occasional freezing that you say will be corrected in a firmware update.
Author:  Technical Support [ Fri Dec 18, 2009 4:45 pm ]
Post subject:  Re: Cyber Commander - won't start after changing batteries
both should be addressed in the firmware update and update process
Author:  jc11 [ Sat Dec 19, 2009 7:42 am ]
Post subject:  Re: Cyber Commander - won't start after changing batteries
Technical Support wrote:
both should be addressed in the firmware update and update process



And how would one get this update?
Author:  Technical Support [ Mon Dec 21, 2009 10:51 am ]
Post subject:  Re: Cyber Commander - won't start after changing batteries
We are working on that now. I will post either a new topic and/or individual replies when we are ready to release it.
Author:  svoelkel [ Mon Dec 21, 2009 2:59 pm ]
Post subject:  Re: Cyber Commander - won't start after changing batteries
If you decide to distribute the revised firmware via individual replies, please add me to the list.

Thanks,
Sam
Author:  bewally [ Wed Dec 23, 2009 2:05 pm ]
Post subject:  Re: Cyber Commander - won't start after changing batteries
Not working after battery change... FWIW had same issue ....pulled out memory card and put back in and Cyber Commander works fine... something to try.... it worked for me....
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/