The Cyber Commander is performing as designed. The function of "ALL" is to affect all lights equally. If it is defined, then it is adjusted. Even if the light was in standby (OFF), it would still block movement that tried to force it lower than minimum.
By its very definition, the Cyber Commander cannot selectively affect some lights in the ALL channel selection.
There are a few options: You can set up two lights as a group (example; GRP8). Instead of going to the ALL setting, you can go to GRP8 and adjust them as a pair, and leave the third light alone.
Or, you can go to spec lights, and specify this one as NONE to remove it.
Or, you can go to Open Memory, and open from studio, and only the two connectged lights will pair.
|