Paul C. Buff, Inc. Technical Forum
https://paulcbuff-techforum.com/

LS3900 + Boom
https://paulcbuff-techforum.com/viewtopic.php?f=8&t=273		 Page 1 of 1
Author:  josh.hofer [ Mon Feb 15, 2010 2:54 pm ]
Post subject:  LS3900 + Boom
I am gearing up here soon to purchase the LS3900 and was wondering if the Paul C. Buff crew had any 'official' suggestions for what boom attachment I should purchase? I'm not trying to break the bank with the purchase either :P

9/10 times I am going to be attaching the 22HOBD to the boom, but every now and again I might toss up the FOB47.

Thanks in advance :)
Author:  Technical Support [ Mon Feb 15, 2010 5:10 pm ]
Post subject:  Re: LS3900 + Boom
Any boom comparable to our old ones should be fine. Make sure it clamps to the stand and does not sit atop the 5/8 stud. I believe Westcott has one (B&H) and Interfit and Savage have some that should also work (Adorama).

this one is darn near identical
http://www.bhphotovideo.com/c/product/4 ... _Arm_.html

TS
Author:  josh.hofer [ Mon Feb 15, 2010 6:48 pm ]
Post subject:  Re: LS3900 + Boom
Technical Support wrote:
Any boom comparable to our old ones should be fine. Make sure it clamps to the stand and does not sit atop the 5/8 stud. I believe Westcott has one (B&H) and Interfit and Savage have some that should also work (Adorama).

this one is darn near identical
http://www.bhphotovideo.com/c/product/4 ... _Arm_.html

TS


Outstanding! Thankie.
Author:  BKRonline [ Fri Feb 26, 2010 8:15 pm ]
Post subject:  Re: LS3900 + Boom
Just to confirm specs, the LS3900 heavy duty stand does have a 1" - 1.25" diameter top section to clamp booms to?

Thanks so much for your time!
Author:  Technical Support [ Mon Mar 01, 2010 10:31 am ]
Post subject:  Re: LS3900 + Boom
Yes, the top section is just over an inch in diameter.
Author:  BKRonline [ Mon Mar 01, 2010 10:35 am ]
Post subject:  Re: LS3900 + Boom
Thanks very much!
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/