A comprehensive set up would essentially be the manual transcribed. However, we will be more than happy to walk you through a set up via teh phone if you would like to call in. This way, the help and trouble shooting are real time, and would be much faster.

For a start, make sure that the CC and all the receivers are all set to the same frequency.

Set each receiver to a unique channel - ch 1, 2, and 3 perhaps.

You will then need to tell the CC what kind of lights you have. Do OPEN MEMORY>OPEN ALL FROM STUDIO. That should get channels 1-3 turned on in the CC. Next, go to SPEC LIGHTS and, for each channel, choose the light you're using. You use the left joystick to cycle between the individual channels.

Once you do all that, you should be able to use all of it. Only connect the receivers to the Bees with the phone cord. Plug the sync cable in the sync port on the Bee but not into the Cybersync receiver (dummy plug) as you mentioned. Make sure the power is turned up all the way on the Bees and that all three model lamp buttons are depressed. Make sure all the channel and frequency knobs are set right. Make sure the phone cord is plugged in well - won't hurt to unplug and reinsert it. It helps to plug the phone cord into the bee last after the light is on.

Hope this helps. If you have trouble with specific steps or something else I'll try to help further.

Any time we are open is a good time. M-F 9-5 central. As a time saver, if you could take a photo of the CC's screen and email it to info@paulcbuff.com, we can see the status of the various channels, and that can cut down a lot of trouble shooting. In the email, just say you will be calling in for assistance.