| Paul C. Buff, Inc. Technical Forum https://paulcbuff-techforum.com/ |
|
| Zeus 2500 3/4 1/4 switch setting & 1 flash head. https://paulcbuff-techforum.com/viewtopic.php?f=8&t=3403 |
Page 1 of 1 |
| Author: | neelin [ Thu Feb 16, 2012 6:43 pm ] |
| Post subject: | Zeus 2500 3/4 1/4 switch setting & 1 flash head. |
Can the 1/4 switch be used with a single head installed in socket B to access 1/16 & 1/32 power? Would there be a problem if the switch was in this position, for firing, while a single head was attached to either socket A or B? Thanks. Robert |
|
| Author: | Technical Support [ Thu Feb 16, 2012 7:46 pm ] |
| Post subject: | Re: Zeus 2500 3/4 1/4 switch setting & 1 flash head. |
When using the ratio switch, if the 1/1 position is selected, one head in A or B will fire full power. If using the 3/4 1/4 switch, the A socket will emit 3/4 the power and the B socket will fire at 1/4 power. There is no harm (and is, in fact a design feature) to use a single head in either A or B. The above powers are assuming the slider is set to FULL. You will still maintain a 5 stop power range relative to the max power in each example. Therefore, using one head in B set to 1/4 will access 1/64 and 1/128 power on the low end. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|