| Paul C. Buff, Inc. Technical Forum https://paulcbuff-techforum.com/ |
|
| Cyber Commander - saving settings https://paulcbuff-techforum.com/viewtopic.php?f=8&t=4815 |
Page 1 of 1 |
| Author: | yitzy [ Sat Aug 15, 2015 8:12 pm ] |
| Post subject: | Cyber Commander - saving settings |
When opening a saved setting from the Cyber Commander, the flash power opens correctly but other settings (modeling on/off, slave and more..) change 'randomly (?)'. I tried this multiple times and saving to different locations (SD/internal) - can't get the CC to save and then remember and open all the flash settings using 6 Einsteins Thanks Yitzy |
|
| Author: | Technical Support [ Sat Aug 15, 2015 8:30 pm ] |
| Post subject: | Re: Cyber Commander - saving settings |
Did you set the lights on the back panel or in the Cyber Commander before you saved? Also, did the SD save location (SD1 SD2 etc; though not internal 1 or 2) turn blue when saved? |
|
| Author: | yitzy [ Sat Aug 15, 2015 8:33 pm ] |
| Post subject: | Re: Cyber Commander - saving settings |
In the Cyber Commander set the CC to ALL channels and set the settings i wanted, then saved. Thanks for your quick response |
|
| Author: | yitzy [ Sat Aug 15, 2015 8:36 pm ] |
| Post subject: | Re: Cyber Commander - saving settings |
Yes i think it turned blue can test again at the wedding tomorrow |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|