Paul C. Buff, Inc. Technical Forum

Technical Discussion Forum for all Paul C. Buff, Inc. Products

Login

Post a reply
 [ 2 posts ] 

Fri May 26, 2017 11:33 pm

Joined: Fri May 26, 2017 11:31 pm
Posts: 1

I have an alien bee that I use a lot. I've never had any issues. I was at a shoot, set everything up and then took a test shot, only the strobe never fired. I hit the test button on the bee, it fires. If I hit the test button on the transmitter, the one that is plugged directly into the bee, it doesnt fire. It does blink green, when I hit test, it blinks red. When I plug the sync cord into the back of the bee, it does trip the flash, so I know it's not the flash, I am assuming it's the sync cord, or the transmitter, is there any way to test the sync cord?




Top Top
Profile
 

#

Sat May 27, 2017 7:42 pm

Site Admin
Joined: Tue Dec 08, 2009 10:43 am
Posts: 5266

If the power cord AND sync cord are plugged in, press the test button on the receiver (the part on the flash). If the light doies not fire, try removing and reinserting the sync cord to the receiver. If the light does not fire, it is likely the sync cord. You can obtain a regular patch cable from the local electronics department.

Also, be sure this is the round 3.5mm/ 1/8" cord and not the telephone cord.




Top Top
Profile
 
Display posts from previous:  Sort by  
Post a reply
 [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 41 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum


cron