| Paul C. Buff, Inc. Technical Forum https://paulcbuff-techforum.com/ |
|
| Please Help! Issues with Einstein 640 https://paulcbuff-techforum.com/viewtopic.php?f=8&t=578 |
Page 1 of 1 |
| Author: | Marloon [ Mon May 17, 2010 7:57 pm ] |
| Post subject: | Please Help! Issues with Einstein 640 |
Hi Guys, I received my Einsteins today. I ordered two of them, and one seems to be faulty. I'll describe it the best I can. The settings on the flash are: -8 fstop flash -8 fstop modelling modeling light is tracking ready is set to audible beep and dimming The slave flash is off I have no receiver plugged into my Einstein. I am plugged into 120V AC power at my house. Whenever I hit the test button, the flash fires. After that, the modeling light does not want to turn on again, and the ready indicator stays red. At -8 fstop, the flash should recycle almost instantaneously, but it doesnt. I did not encounter this issue with my other einstein. I am sure that PCB has tested these flashes because the count says 500. I just don't know what's happening. Please help! haha. |
|
| Author: | Technical Support [ Tue May 18, 2010 3:23 pm ] |
| Post subject: | Re: Please Help! Issues with Einstein 640 |
The lack of recycling means there is somehting internal not right. It will have to be replaced. Please contact customer service to arrange this. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|